GGP ITALY MM48Li Manual De Instrucciones página 69

5
EN
LEAVING THE BATTERY IN THE CHARGER
The charger and battery pack can be left connected
indefinitely with the LED lit. The charger will keep the
battery pack fresh and fully charged.
CHARGER DIAGNOSTICS
If the charger detects a weak or damaged battery, the
charging indicator (24) will flash red at a fast rate.
Proceed as follows:
■ Re-insert the battery (10).
■ If the charging indicator continues flashing red at a
fast rate, use a different battery to determine if the
charging process works properly.
■ If the replaced battery charges correctly, the original
battery is defective and should be returned to a
service centre for recycling.
■ If the new battery gives the same indication as the
original battery, take the charger to be tested at an
authorised service centre.
■ Note It may take as long as 60 minutes to determine
that the battery is defective.
Symbols on the charger
The following symbols are found on your charger:
Your charger is double insulated; therefore no earth wire
is required. Always check that the mains voltage
corresponds to the voltage on the rating plate. Never
attempt to replace the charger unit with a regular mains
plug.
If the cord is damaged, it must be replaced by the
manufacturer or an authorised Service Centre in order to
avoid a hazard.
The charger is intended for indoor use only.
Read the instruction manual before use.
2. SYMBOLS
wARNING
The following warning symbols are shown on the
tool.
GENERAL SAFETY wARNINGS /SYMBOLS
SYMBOL DESIGNATION/EXPLANATION
Warning! To reduce the risk of
injury, the user must read the
instruction manual.
Do not expose the tool to rain or
high humidity.
Always wear the gloves when use
the chain saw.
Beware of falling objects. Keep
bystanders away.
Electrocution hazard. Keep at least
10 m away from overhead lines.
A l ways we a r h e a d a n d eye
protection.
Wear non-slip safety footwear.
Always wear ear and eye protection.
Always wear ear and eye protection.
Warning! Do not touch chain at the
chip ejection point.
Warning! Do not touch the chain at
the chip ejection point.
To e n s u r e c o n t i n u e d s a f e
operation, check the chain tension
as described in this manual after
every 10 minutes of use, and adjust
back to a clearance of 3 mm as
required.