Proxxon LHW/A Manual De Instrucciones página 12

Further special safety guidelines on abrasive
cutting:
a) Avoid jamming the cutting disc or applying
too great contact pressure. Do not make
excessively deep cuts. Overstressing the
cutting disc increases its load and its suscep-
tibility to twisting or jamming and thus the
possibility of recoil or grinding tool breakage.
b) Avoid the area in front of and behind the
rotating cutting disc. If you move the cut-
ting disc in the work piece away from you,
recoil may catapult the power tool with the
rotating disc directly towards you.
c) If the cutting disc binds or if you inter-
rupt work, switch off the device and
hold it still until the disc has come to
a complete stop. Never attempt to pull
the running cutting disc out of the cut,
otherwise recoil may occur. Determine
and eliminate the cause for binding.
d) Do not switch the power tool back on as
long as it is in the work piece. Allow the
cutting disc to reach its full rotational
speed before carefully continuing the
cut. Otherwise, the disc can get snagged,
jump out of the work piece or cause recoil.
e) Support sheets or large work pieces to
minimize the risk of recoil caused by a
jammed cutting disc. Large work pieces
can sag under their own weight. The work
piece must be supported on both sides of
the disc; namely near the separating cut as
well as at the edge.
f) Be especially careful when making "po-
cket cuts" in existing walls or other blind
areas. The dipping cutting disc can cause
recoil when cutting into gas or water lines,
electric cables or other objects.
Special safety guidelines on sanding:
a) Do not use any overdimensioned san-
ding disc papers, but comply with
manufacturer's specifi cations on san-
ding paper size. Sanding papers that ex-
tend beyond the grinding disc can cause
injuries as well as lead to binding, tearing of
the sanding discs or recoil.
- 14 -
For your safety, always wear hearing pro-
tection while working!
Use only in dry rooms
Charger LHW/A
Protection class II device
Please do not dispose of this electrical de-
vice, the charger and the battery with the
household waste!
WARNING
Always wear protective goggles
Description of the machine
The user who frequently uses his long-neck
angle grinder in cramped spaces will apprecia-
te the device. A slender shape, imposing power
and a comprehensive range of accessories
make the LHW/A the ideal tool for deburring,
rough-machining, precision polishing, round-
ing off edges, colour removal, removing rust,
separating small parts and sharpening of tools.
The LHW/A can easily machine many materials,
such as for example steel, non-ferrous metals,
glass, wood and ceramics. Ideally suited for
model, tool and mould construction, but also,
for example, in the motor vehicle sector or for
repairs to vehicles. The fl at end cap of the bat-
tery enables the tool to stand upright as well.
The defl ection is achieved through the precise,
double ball-bearing bevel gear. It is driven by
a powerful special motor which is effi ciently
force-cooled against overheating. A sanding
disc of high-grade corundum (grit 60), a fan
sander (grit 100) and a fabric-reinforced cutting
disc are included.
Powerful batteries in lithium-ion technology
and 2.6 Ah capacity guarantee continuous, high
performance work. To charge the battery, it is
simply inserted into the charger and is ready
for operation again within approx. 1 hour. For
your safety the process is thermally monitored.