Uline H-9330 Instrucciones De Montaje página 6

OPERATING ISSUE
Fan will not start.
Fan sounds noisy.
Fan wobbles or
shakes excessively.
PAGE 6 OF 19
TROUBLESHOOTING
Check wiring connection to fan.
Turn power off and check fuses and circuit breakers.
Turn power off and check wiring connections in switch housing.
Ensure all screws in motor housing are snug.
Ensure blade bracket screws are tight.
Ensure wire nuts in switch housing are not rattling against wall of switch housing.
If fan has a light kit, make sure switch housing screws and set screws are tight.
Some fan motors are sensitive to signals from solid state variable controls. If
solid state controller is used, change to an alternative control.
Allow a 24-hour break-in period to eliminate most noises.
Check that all blades are screwed firmly into blade brackets.
Check that blade brackets are secured firmly to motor.
Check distance from tip of blades to ceiling.
Check distance from blade tip to blade tip. All measurements should be
equal. Loosen blade screws and re-position blade until even, then re-tighten.
Check that the downrod hemisphere notch is engaged in canopy.
Check that jam screws in the downrod are tightened.
Ensure canopy and mounting bracket are tightened securely to wooden joist.
Ensure warpage has not occurred in wooden blades. If so, contact Uline
Customer Service at 1-800-295-5510 for replacement parts.
1-800-295-5510
uline.com
RECOMMENDATIONS
0721 IH-9330