Troubleshooting - brondell Swash Ecoseat 101 El Manual Del Propietario

TROUBLESHOOTING

If the bidet appears to be operating abnormally, please review the troubleshooting tips before
calling the Brondell Service Center as most issues are easily resolved with a few simple steps .
If you are unable to resolve the issue after checking the following items, please call the Service
Center at 888-542-3355, Mon–Fri, 9am–5pm PST, or email us at support@brondell .com .
Check before continuing:
• Make sure main water supply valve is open .
• Confirm there are no leaks from hoses or water supply .
After checking items above, refer to the following troubleshooting chart for additional solutions .
Problem
Low water flow or 1 . Water supply valve not
spray pressure opened fully
2 . Nozzles dirty
3 . External bidet filter
Nozzles do not 1 . Nozzles are dirty
function properly
2 . Water pressure is too low
3 . External bidet filter
Water leaks from 1 . Water leaking from the T-valve
areas other than
the nozzles
2 . Water leaking from the bidet
hose connection
Possible Cause(s) Solution(s)
1 . Check that the water supply valve at
wall is fully open .
2 . Clean nozzles
(see maintenance section) .
3 . If you have an external bidet filter
like SWF44, check and replace
if necessary .
1 . Clean nozzles
(see maintenance section) .
2 . Check water supply valve at wall to
fully open .
3 . If you have an external bidet filter
like SWF44, check and replace
if necessary .
1 . Make sure that the rubber gasket is
inserted correctly into the T-valve .
2 . Make sure that the bidet hose is
correctly connected and tight . Check
any rubber washers and do
not overtighten .
11 11