Toshiba 16SAVP2 Serie Manual Del Propietário página 2

PRECAUTIONS FOR SAFETY
• Do not install, repair, open or remove the cover. It may expose you to
dangerous voltages. Ask the dealer or the specialist to do this.
• Turning off the power supply will not prevent potential electric shock.
• The appliance shall be installed in accordance with national wiring
DANGER
regulation.
• Means for disconnection from the supply having a contact separation of
at least 3 mm in all poles must be incorporated in the fi xed wiring.
• Do not expose your body directly to cool air for a long time.
• Do not insert your fi nger or any article into the air inlet/outlet.
• When an abnormality (burning smell, etc.) occurs, stop the air
conditioner and disconnect the power supply or turn off the breaker.
• This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible
WARNING
for their safety.
• Children should be supervised to ensure that they do not play with the
appliance.
• Do not use any refrigerant different from the one specifi ed for
complement or replacement. Otherwise, abnormally high pressure may
be generated in the refrigeration cycle, which may result in a failure or
explosion of the product or an injury to your body.
• Do not wash the unit with water. It may cause an electric shock.
• Do not use this air conditioner for other purposes such as preserving
food, breeding animal, etc.
• Do not step or put anything on the indoor/outdoor unit. It may cause an
injury or damage the unit.
• Do not touch aluminium fi n because it may cause an injury.
• Before cleaning the unit, turn off the main switch or the circuit breaker.
CAUTION
• When the unit won't be used for a long time, turn off the main switch or
the circuit breaker.
• It is recommended that maintenance be performed by a specialist when
the unit has been operated for a long time.
• The manufacturer shall not assume any liability for the damage caused
by not observing the description of this manual.
INDOOR UNIT DISPLAY
1
4
Hi POWER FILTER PURE TIMER
1 2 3
PREPARATION BEFORE USE
2
Preparing Filters
1. Open the air inlet grille and remove the air fi lters.
2. Attach the fi lters. (see detail in the accessory sheet).
Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type) following the (+)
and (–) positions.
Clock Setup
1. Push by tip of the pencil.
2. Press : adjust the time.
3. Press : Set the time.
Remote Control Reset
Press for reset.
AIRFLOW DIRECTION
3
Press : Move the louver in the
1
desired vertical direction.
Press : Swing the air automatically
2
and press again to stop.
3
For horizontal direction, adjust manually.
Note:
• Do not move the louver manually by others.
• The louver may automation positioning by some operation mode.
5
1 Hi POWER (Green)
2 FILTER (Orange)
OPERATION
3 PURE (Blue)
4 TIMER (Yellow)
5 OPERATION (Green)
RESET
6 RESET button
6
REMOTE CONTROL
4
1 Infrared signal emitter
2 Memory and preset button (PRESET)
3 Start/Stop button
4 Temperature up/down and Timer
or clock up/down button (TEMP.)
5 Mode select button (MODE)
6 Swing louver button (SWING)
7 Fan speed button (FAN)
8 One Touch button (ONE-TOUCH)
9 Set louver button (FIX)
0 8 degree celcius operation button (8°C)
- Economy button (ECO)
= High power button (Hi-POWER)
~ Plasma Air Purifi er button (PURE)
! Comfort sleep button (COMFORT SLEEP)
@ Power selection button (POWER-SEL)
# On timer button (ON)
$ Off timer button (OFF)
% Setup button (SET)
^ Clear button (CLR)
& Clock setup button (CLOCK)
* Check button (CHECK)
( Filter reset button (FILTER)
) Reset button (RESET)
ONE-TOUCH
5
Press the "ONE-TOUCH" button for fully automated operation that is customised
to the typical consumer preferences in your region of the world. The customised
settings control temperature air fl ow strength, air fl ow direction and other settings
to provide you alternate contact with "ONE-TOUCH" of the button. If you prefer
other settings you can select from the many other operating functions of your
Toshiba unit.
Press : Start the operation.
AUTOMATIC OPERATION
6
To automatically select cooling, heating, or fan only operation
1. Press : Select A.
2. Press : Set the desired temperature.
3. Press : Select AUTO, LOW , LOW+
MED+ , HIGH
COOLING / HEATING / FAN ONLY OPERATION
7
1. Press : Select Cool
2. Press : Set the desired temperature.
Cooling: Min. 17°C, Heating: Max. 30°C, Fan Only: No temperature indication
3. Press : Select AUTO, LOW , LOW+
MED+ , HIGH
Note: QUIET is supper low fan speed for quiet operation.
DRY OPERATION (COOLING ONLY)
8
For dehumidifi cation, a moderate cooling performance is controlled automatically.
1. Press : Select Dry
2. Press : Set the desired temperature.
AIR PURIFYING OPERATION
9
During air conditioner operation
Press to start and stop plasma air purifi er and air ionizer operation.
The plasma air purifi er and air ionizer can be activated or deactivated during air
conditioner is stopped and the air ionizer starts in conjunction with plasma air
purifi er operation.
Note: The FILTER indicator (orange) turns on after PURE operation is performed
for about 1000 hours.
Hi-POWER OPERATION
10
To automatically control room temperature and airfl ow for faster cooling or heating
operation (except in DRY and FAN ONLY mode)
Press : Start and stop the operation.
ECO OPERATION
11
To automatically control room to save energy (except in DRY and FAN ONLY
mode)
Press : Start and stop the operation.
Note: Cooling operation; the set temperature will increase automatically 1
degree/hour for 2 hours (maximum 2 degrees increase). For heating
operation the set temperature will decrease.
1
2
3
5
8
10
13
16
17
20
21
, MED ,
, or Quiet .
, Heat , or Fan only .
, MED ,
, or Quiet .
.
4
6
7
9
11
12
14
15
19
18
23
22