Mounting Accessories - Worx Sonicrafter WX676 Manual Original

OPERATION INSTRuCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The power tool is intended for sawing and
remodelling wooden materials, plastic,
plaster, non-ferrous metals and fasteners
(e.g. nails and clamps) as well as for working
on soft wall tiles and for dry grinding of small
surfaces. It is especially suitable for working
close to edges and for flush cutting.

1. MOUNTING AccESSORIES

cAUTION: For all work or when
changing accessories, always wear
protective gloves. Avoid danger of injury
from the sharp edges of the accessories.
Accessories can become very hot while
working, presenting danger of burns! Make
sure the tool is unplugged prior to
changing accessories.
wARNING: To reduce the risk of
injury, do not let the sharp side of
the accessory face back toward the
10
user's hand.
- Loosen the Flange
Use the Allen Key to rotate the Flange
clockwise. (See Fig. A)
- Insert Accessories
Insert the Accessory onto the Universal Fit
Accessory Interface. (See Fig. B)
- Tighten the Flange
- Use the Allen Key to rotate the Flange
counterclockwise until accessory is tightened
securely. (See Fig. C)
NOTE: For prior model Worx Sonicrafter
hex-interface accessories and most other
non-WOrx branded accessories, the Flange
must be completely removed to install
accessory (See Fig. D).
2. MOUNTING/cHANGING THE
SANDING SHEET (See Fig. E)
Align the sanding sheet and press it onto the
sanding pad by hand.
Firmly press the power tool with the sanding
sheet against a flat surface and briefly switch
the power tool on. This provides for good
Oscillating Tool
adhesion and prevents premature wear.
If one point has become worn, pull off the
sanding sheet, turn it 120° and place it on
again.
NOTE: For other various brands' sanding
pad, use small flange provided.
3.MOUNTING THE SUcTION DEVIcE
(See Fig. F-J)
When vacuuming, mount the suction device
as shown in F-J.
NOTE: Using the sanding pad perforated. You
can only do the vacuuming after fitting the
dust collector.
4. OPERATING THE ON/OFF SwITcH
To start the machine, push the On/Off switch
forward so that the "I" is indicated on the
switch.
To switch off the machine, push the On/Off
switch toward the rear so that the "0" is
indicated on the switch.
5 USING THE VARIABLE SPEED DIAL
Select oscillation frequency (speed) while the
motor is running.
The Variable Speed Dial can be used to set
the optimum oscillating frequency according
to the accessories used and the respective
application.
High oscillation frequency:
Sanding, sawing, rasping and polishing stone
TM
and metal.
Low oscillation frequency:
Scraping, polishing varnishes.
6. SANDING
Typical application: wood, metal; small areas,
especially corners, edges and places difficult
to access.
Select high oscillation frequency.
Sand with a constant movement and light
pressure.
Heavy pressure does not increase the
removal – the sanding sheet merely wears
faster.
EN