Priority Channel 9; Function Menu; Ctcss/Dcs - Menu: Cdtset; Beep Tone - Menu: Keybp - Team Electronic TS-11VI Manual De Instruccion

TEAM TS-11vi English

Priority Channel 9/19

The TS-11vi is equipped with two priority channels, these are preset to the
channel numbers 9 [EMG1] and 19 [EMG2].
The priority channel key [EMG] (4) uses a triple switch to change between pri-
ority channel 1, priority channel 2 and the selected channel in regular mode.

FUNCTION MENU

The function menu manages the following list of functions and their settings.
To access the function menu, press the menu key [EMG] (4) until the regular-
mode screen switches to the first menu function. The function name is dis-
played on the left, next to the current function setting.
To navigate through the list of menu functions, use the channel selector keys.
To access a function for changing the current setting, press the menu key
[EMG] shortly. The current setting of the selected function starts blinking. Use
the channel selectors to change the setting and press the menu key [EMG]
again to save your selection.
The functions CTCSS/DCS and EMG require more than one step for the con-
figuration. Nevertheless, the procedure of selecting (with the channel selec-
tors) and confirming (with the menu key [EMG] remains the same.
To exit the menu, press the menu key [EMG] long. Some menu functions

CTCSS/DCS - Menu: CdTSET

CTCSS and DCS filter unwanted signals on busy frequencies. If activated,
only received signals with the same code will pass and will be audible in the
speaker. Please note: CTCSS/DCS is not a security feature. With the monitor
function or an open squelch, CTCSS-/DCS-encoded signals can be heard.
With this function, select the code type first, i.e. either CTCSS (Ct) or DCS (dt)
and then the according code, i.e. CTCSS: 1-38 and DCS: 1-104.

Beep Tone - Menu: KEyBP

A beep tone, for confirmation of any key entry, can be activated/deactivated.

Scan Mode - Menu: SCM

The channel scan has two different modes available that determine how long
the scan function pauses on a frequency when a signal has been detected.
Menu Sq (Squelch):
25