Fuse; External Speaker; Microphone Connection; Overview Functions - Team Electronic TS-11VI Manual De Instruccion

TEAM TS-11vi

Fuse

The power supply cable fixed to the TS-11vi is equipped with one 15A/250V
fuse. Beware using the correct, according fuse. Damages to the radio can
occur when using the wrong fuse.
If the fuse blows, determine the cause, then solve the problem. After the
problem is resolved, replace the fuse. If newly installed fuses continue to blow,
disconnect the power cable and contact your authorized dealer or an autho-
rized service center.

External Speaker

External 8 Ohm speakers must have a 3.5 mm plug which has to be con-
nected to the speaker connection (11). Beware of the length of the cable when
determining the position.

Microphone Connection

Plug the microphone plug into RJ45 socket (3), located on the front panel.
Pay attention to proper placement. No transmission is possible without the
microphone.
Please note that for transmission, the microphone has to be connected.
• 38 CTCSS / 104 DCS Codes
• VOX - Sensitivity and Delay
• Multi Frequency Norm
• LCD with seven background colors and 6 brightness levels
• Squelch - automatic and manual
• Channel Scan
• RF Gain
• Priority Channels 9/19
• AM / FM Mode
• Channel Selectors Up and Down, at Radio and Microphone
• Connector for external Speaker
• Automatic 12/24V Switch
• Keylock
• Beep Tone, on/off
• Automatic Noise Limiter / Noise Blanker (ANL/NB)
• Talkback
• HI-CUT
• Roger Beep
• S-Meter for TX and RX

OVERVIEW FUNCTIONS

English
21