Samsung FlexDry DVEG60A9900 Serie Manual Del Usuario página 28

Installation
Using the short hose as an extension
C
28 English
Untitled-5 28
1. Close the cold water tap. If you have a washer's cold
2. Using pliers, tighten the coupling an additional two-
3. Connect the Y-connector (A) to the brass male end
B
4. Using pliers, tighten the coupling an additional two-
5. Connect the angled end of the water hoses (C) to the
A
6. Using pliers, tighten the coupling an additional two-
7. If you detached the cold water hose from your
8. Open the cold water tap, and then check for any
water hose attached to the cold water tap, unscrew
and remove the hose. Then, connect the short hose
(B) to the cold water tap. Turn the coupling by hand
until it is tight.
thirds turn. Do not overtighten. You can damage the
coupling.
of the short hose. Turn the coupling by hand until it
is tight.
thirds turn. Do not overtighten. You can damage the
coupling.
filling valve at the bottom rear of the dryer. Turn the
coupling by hand until it is tight.
thirds turn. Do not overtighten. You can damage the
coupling.
washer, attach the hose to the free end of the
Y-connector, tighten the coupling by hand until it is
tight, and then, using a pliers, tighten an additional
two-thirds turn.
leaks.
2021-05-25 5:20:39