Makita 2414DB Manual De Instrucciones página 7

Tronzadora de metal
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

► 1 . Blocks
OPERATION
Hold the handle firmly. Switch on the tool and wait until
the wheel attains full speed before lowering gently
into the cut. When the wheel contacts the workpiece,
gradually bear down on the handle to perform the cut.
When the cut is completed, switch off the tool and WAIT
UNTIL THE WHEEL HAS COME TO A COMPLETE
STOP before returning the handle to the fully elevated
position.
CAUTION:
Proper handle pressure during cutting and maxi-
mum cutting efficiency can be determined by the
amount of sparks that is produced while cutting.
Your pressure on the handle should be adjusted
to produce the maximum amount of sparks. Do
not force the cut by applying excessive pressure
on the handle. Reduced cutting efficiency, pre-
mature wheel wear, as well as, possible damage
to the tool, cut-off wheel or workpiece may
result.
Cutting capacity
Max. cutting capacity varies depending upon the cutting
angle and workpiece shape. Applicable wheel diameter:
355 mm (14")
Workpiece
1
shape
Cutting
angle
90°
45°
Workpiece
shape
Cutting
angle
90°
45°
Carrying tool
Fold down the tool head to the position where you can
attach the chain to the hook on the handle.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
7 ENGLISH
115 mm (4-1/2")
119 mm (4-11/16")
115 mm (4-1/2")
106 mm (4-3/16")
115 mm x 130 mm
(4-1/2" x 5-5/8")
102 mm x 194 mm
137 mm (5-3/8")
(4" x 7-5/8")
70 mm x 233 mm
(2-3/4" x 9-1/8")
115 mm x 103 mm
100 mm (3-15/16")
(4-1/2" x 4-1/16")
Tabla de contenido
loading

Tabla de contenido