Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1
2
3
4
► 1 . O-ring 2. Inner flange 3. Ring 4. Spindle 5. Cut-off
wheel 6. Outer flange 7. Hex bolt
CAUTION:
•
Be sure to tighten the hex bolt securely.
Insufficient tightening of the hex bolt may result
in severe injury. Use the socket wrench provided
to help assure proper tightening.
•
Always use only the proper inner and outer
flanges which are provided with this tool.
•
Always lower the safety guard after replacing
the wheel.
Securing workpiece
1
► 1 . Vise plate 2. Vise nut 3. Vise handle
By turning the vise handle counterclockwise and then
flipping the vise nut to the left, the vise is released from
the shaft threads and can be moved rapidly in and out.
To grip workpieces, push the vise handle until the vise
plate contacts the workpiece. Flip the vise nut to the
right and then turn the vise handle clockwise to securely
retain the workpiece.
CAUTION:
•
Always set the vise nut to the right fully when
securing the workpiece. Failure to do so may
result in insufficient securing of the workpiece.
This could cause the workpiece to be ejected or
cause a dangerous breakage of the wheel.
When the cut-off wheel has worn down considerably,
use a spacer block of sturdy, non-flammable material
behind the workpiece as shown in the figure. You can
more efficiently utilize the worn wheel by using the mid
point on the periphery of the wheel to cut the workpiece.
7
6
5
► 1 . Spacer block
When cutting workpieces over 65 mm (2-9/16") wide at
an angle, attach a straight piece of wood (spacer) over
190 mm (7-1/2") long x 45 mm (1-3/4") wide to the guide
plate as shown in the figure. Attach this spacer with
screws through the holes in the guide plate.
2
► 1 . Guide plate 2. Straight piece of wood (Spacer)
If you use a spacer block which is slightly narrower
than the workpiece as shown in the figure, you can also
utilize the wheel economically.
3
► 1 . Diameter of workpiece 2. Guide plate 3. Spacer
Long workpieces must be supported by blocks of
non-flammable material on either side so that it will be
level with the base top.
6 ENGLISH
1
2
3
4
3. Over 45 mm (1-3/4") long 4. Over 65 mm
(2-9/16") long 5. Over 190 mm (7-1/2") long
1
5
4
block 4. Width of spacer block 5. Vise
1
5
2
3
Tabla de contenido
