Connecting Power; Initial Calibration - OHAUS Scout SPX Serie Manual De Instrucciones

TM
SCOUT SERIES BALANCES - SPX

2.4 Connecting Power

AC Adapter Installation
AC power is used to power the scale when battery power is not needed. First, connect the AC
Adapter (supplied) to the AC Adapter Input Jack at the rear of the balance then connect the AC
plug to an electrical outlet.
AC Adapter Input Jack
Interface Connection
Battery Installation
Install the four "AA" batteries with polarity as shown in the battery compartment.
Note:
After power on, it is recommended to warm up the balance for at least 5 minutes before using it.

2.5 Initial Calibration

When the Balance is first installed, and when it is moved to another location, it must be
calibrated to ensure accurate weighing results. Have the appropriate calibration masses
available before beginning calibration. Refer to the Calibration Section for masses and
calibration procedure.
Security slot (Anti-theft lock slot)
Figure 2-4. Rear and bottom view of balance
Weigh Below Hole
Security Switch
Battery Compartment Cover
EN-3