Leveling The Scale; Connecting Power; Ac Power; Battery Maintenance - OHAUS Aviator 3000 Serie Manual De Instrucciones

Aviator 3000 Series

2.4 Leveling the Scale

Adjust the leveling feet until the bubble is centered in the circle of the level
indicator (located on the front panel). Ensure that the scale is level each
time its location is changed.

2.5 Connecting Power

2.5.1 AC Power

Verify that the intended AC power source matches the AC adapter rating.
Connect the adapter to the power receptacle underneath and to the right of
the scale, then plug the AC adapter into a properly grounded power outlet.

2.5.2 Battery Maintenance

Battery type
Aviator 3000 Series provides alternative to use battery. You can see the left
sticker in the battery holder.
The default status is that the switch is covered by the sticker, and default
location of the switch is on the NiMH side, it means to only use rechargeable
NiMH batteries of size UM1.
If you would like to use D-cell, please break the box in the middle of the
sticker, and push the switch to the D-cell side, in this status, charging
function is disabled automatically.
Always make sure that all six batteries have the same capacity. Please
contact your authorized dealer for more information.
CAUTION:
Whenever you change the battery, please check the switch location
to be sure that you chose the right battery type.
Installation
Attention: Before you install the batteries, make sure that the
external power supply is disconnected.
Carefully put the scale on its side. Remove battery cover by pressing the
two buttons and pull it out. Then install the batteries as shown on the battery
holder. Reattach the battery cover when the batteries have been installed
correctly.
EN-5