Camera Parts - flir i5 Manual De Instrucciones

Do not put the batteries in or near a fire, or into direct
sunlight. When the battery becomes hot, the built-in safety
equipment becomes energized and can stop the battery
charging process. If the battery becomes hot, damage can
occur to the safety equipment and this can cause more heat,
damage or ignition of the battery.
Do not put the battery on a fire or increase the temperature
of the battery with heat.
Do not put the battery on or near fires, stoves, or other high-
temperature locations.
Do not solder directly onto the battery.
Do not use the battery if, when you use, charge, or store the
battery, there is an unusual smell from the battery, the
en-US
battery feels hot, changes color, changes shape, or is in an
unusual condition. Contact your sales office if one or more of
these problems occurs.
Only use a specified battery charger when you charge the
battery.
The temperature range through which you can charge the
battery is ±0°C to +45°C (+32°F to +113°F). If you charge the
battery at temperatures out of this range, it can cause the
battery to become hot or to break. It can also decrease the
performance or the life cycle of the battery.
The temperature range through which you can discharge the
battery is −15°C to +50°C (+5°F to +122°F). Use of the battery
out of this temperature range can decrease the performance
or the life cycle of the battery.
When the battery is worn, apply insulation to the terminals
with adhesive tape or similar materials before you discard it.
Do not apply solvents or similar liquids to the camera, the
cables, or other items. This can cause damage.
Be careful when you clean the infrared lens. The lens has a
delicate anti-reflective coating.
Do not clean the infrared lens too vigorously. This can
damage the anti-reflective coating.
Disposal of electronic waste
As with most electronic products, this equipment must be
disposed of in an environmentally friendly way, and in
accordance with existing regulations for electronic waste.
Please contact your FLIR Systems representative for more
details.

Camera parts

1 Infrared lens
2 Lever to open and close the lens cap
3 Trigger to save images
4 Cover for the connectors and the
miniSD™ memory card slot
5 Cover for the battery compartment
6 Attachment point for the hand strap