Repair And Maintenance; Maintenance And Cleaning - THOMSON TWIN720DP Manual Del Usuario

REPAIR AND MAINTENANCE

Consult the following table if there is a problem with the appliance.
Problems
Picture without sound
No sound, no picture
Sound without picture
Poor picture or sound
quality

mAINTENANCE AND CLEANING

• Unplug the appliance before cleaning it.
• Remove finger prints and dust with a soft and slightly damp cloth. Do not use abrasive products or solvents that may
damage the appliance's surface.
ATTENTION: Never immerse the appliance in water or in any liquid whatsoever.
• If it is not used for a long time, unplug the appliance and remove the batteries.
Parsons International France - 63 Avenue de l'Europe - 77184 Emerainville – France
EN 24
Solutions
• Check that the audio connectors are
connected properly.
• Check that the audio connectors are
not damaged.
• Check that the volume is high in the
VOL/CH section.
• Check that the audio parameters have
been correctly defined for the player.
• Check that the audio parameters have
been set up correctly for your television
set.
• Check that the sound has not been
turned off.
• Check that ON/OFF is set to ON.
• Check that the plug is plugged in
correctly.
• Check that the electrical cable's plug
has been plugged into the mains socket.
• Check that the indicator light (LED)
is lit up.
• Check the connections.
• Check that the video cable is
connected to the video input of the
television set (not to an audio output).
• Check that your television set's video
input has been selected correctly.
• Check that the video connectors are
not damaged.
• Check that the parameters have been
set up correctly for your television set.
• Check that the audio parameters have
been set up correctly for your television
set.
• Check that the disk is clean and not
scratched.
• Check that the AV connectors are in a
good condition.
is a trademark of
PORTABLE DVD PLAYER
TWIN720DP
Problems
The remote control does
not work
"No disk" is displayed
No sound
Picture dark
S.A. used under license by:
Solutions
• Check that the
remote control's
battery is working.
• Point the remote
control towards the
player's infrared
sensor.
• Remove the
obstacles between the
remote control and the
player.
• Make sure that you
have inserted a disk in
the player.
• Check that the disk
has been inserted
correctly.
• Check that the disk
is not deformed, dirty
or scratched.
• The volume is set to
the minimum level.
• Make sure that
the disk is not dirty,
scratched or damaged.
• A pair of SPEAKERS
is connected to the
unit.
• Adjust the brightness
and contrast