Cosatto RAC Come and Go i-Rotate Manual De Instrucciones página 8

Upper seat liner:
9:
Refitting the upper seat liner.
Seat liner:
10:
When your child's height is below 75 cm, the child car seat must be used WITH the
seat liners and wedge.
When your child's height is between 75 and 83 cm, the child car seat can be used
with the seat liners only, WITHOUT the wedge.
When your child's height excess 83 cm, the child car seat can be used WITHOUT the
seat liners and the wedge.
Securing your child in the child car seat:
11:
Open the harness (a), (refer to
Raise the headrest (b), (refer
12: Place your child in the child car seat.
Close the harness (a),
Adjust the headrest (b), (refer to
Tighten the harness (c), (refer to
NOTE: The harness must be reasonably tight. It should restrain but not make the
child uncomfortable. Check that the straps are not twisted while the child is seated.
13: Satisfactory harness position:
Location:
WARNING: Ensure that your vehicle has ISOFIX anchor points.
14:
Refer to the vehicle list in this manual for information of where the child car seat base
will fit in your vehicle.
ISOFIX guide (optional):
15: Fitting:
Removing is a reversal of this procedure.
Fitting the child car seat to your vehicle:
IMPORTANT: Always fit your child car seat to the vehicle BEFORE
your child secured to the seat.
16:
Open the ISOFIX support-leg (a).
Pull the ISOFIX arm strap (b) and fully extend the ISOFIX arms (c).
17:
Position the child car seat on the vehicle seat (a).
Engage the ISOFIX arms (b) and ensure that the ISOFIX arm security indicators are
green (c).
18: Press the side release button (a) and push the base back until it rests firmly against
the vehicle seat backrest (b).
19:
Adjust the support-leg (a) until it makes firm contact with vehicle floor (b) and the
support-leg contact indicator is green (c).
5
step 3).
to step 5).
(refer to step 4).
step 5).
step 2).