Haier MRV Serie Instrucciones De Instalación página 11

INSTALLATION INSTRUCTIONS
Dimensions and Service Clearances
Model
MVAD007~12MV2AA
MVAD018~24MV2AA
Hanger dimensions
Dimensions of return air inlet
Installation modes of Indoor unit
This series of air conditioners can be arranged in two air return modes:
1. Air return from the back (factory default).
2. Air return from the bottom (can be adjusted on site). See the following figures.
Note: The downward air return mode will increase noise 3-5dB(A). It is recommended to install the air conditioner in
downward return air mode (figure 2) if enough space is available.
Air return from the back
Figure 1
Installation space and method
Body installation
1. Use 3/8" (M10) all-thread rod.
2. Ceiling removal: Please consult with an engineer about changes to the building structure.
a. Ceiling reinforcement: Ensure the ceiling is stable and will not shake. The ceiling base frame must be reinforced.
b. Cut off and remove the ceiling base frame.
c. Reinforce the faces left when the ceiling is removed and further reinforce the base frame that fix both ends of the ceiling.
d. Install piping and wiring after the indoor unit installation is complete. Before installation, choose a suitable installation
position and determine the outgoing direction of pipes. Especially in case that a ceiling exists, please pull refrigerant
tubing, drain hoses, and wiring to their positions prior to actually hanging the indoor unit.
31-5000500 Rev. 0
A B C D
16.5 35.1 14.6 33.5
16.5 47.7 14.6 46.1
b
h
Air return from the bottom 1
Figure 2
E F G H
7.3 25.2 3.6 29.9
7.3 37.8 3.6 42.5
Dimension of air outlet
30
Air out
Dimensions of drain hose
UP
Air out
Air return from the bottom 2
I
6.0
6.0
d
f
Dimensions of pump drainage
hole, OD 1"
Dimensions of natural
drainage hole, OD 1"
Figure 3
Air in
Air in
11