Regular Checks; Maintenance - TEUFELBERGER multiSAVER Manual Del Usuario

to the surface for about 3 minutes and allow the
product to dry naturally. Be sure to observe the
safety instructions for the use of the disinfectant.
If you fail to observe these provisions, you will be
putting yourself into danger!

7. REGULAR CHECKS

Checking the equipment at regular intervals is ab-
solutely necessary: your safety depends on the
effectiveness and durability of the equipment!
Following each use, the product should be checked
for abrasion and cuts. Also check it for the legibility
of the product labelling! The use of damaged com-
ponents or components subjected to a fall must be
discontinued at once. If there is only the slightest
doubt, the product needs to be retired or subjected
to testing and by a competent person.
When using the equipment in occupational health and
safety to EN 365, it must be checked at least every 12
months by a duly qualified person strictly observing
the instructions, or else by the manufacturer, and
it must, whenever necessary, be replaced. These
inspections must be documented (documentation
of equipment; cf. the following table). It is advisa-
Product inspection record sheet:
Manufacturer:
TEUFELBERGER
Fiber Rope GmbH,
Vogelweiderstraße 50,
A-4600 Wels
Batch No.:
Date of Production:
Compatible components within harness based work at height systems:
Comments:
Model: multiSAVER
Serial No.:
Purchase Date:
regular checks / maintenance
ble to mark the anchor divice with either the next
or the latest date of inspection. Refer to national
regulations for inspection intervals.
Such inspections must at least comprise the
following:
– Check of general state: age, completeness, soiling,
correct assembly
– Check of label: Does it exist? Is it legible? Is there a
CE marking? Does it specify the year of manufac-
ture?
– Check of all individual parts for mechanical damage
such as: cuts, cracks, indentations, abrasion, forma-
tion of ribs, kinks, crushing.
– Check of al individual parts for thermal or chemical
damage such as: fusing, hardening.
– Check of metal components for corrosion and
deformations.
– Check of condition and completeness of end
connections, stitching (e.g. no abrasion of sewing
thread), splices (e.g. no slippage), knots.
Again, the following rule applies: If there is only
the slightest doubt, the product needs to be retired
or subjected to testing by a competent person.

8. MAINTENANCE

Repairs may be carried out only by the manufacturer.
Retailer:
Name of User:
Date of First Use: Date of Retirement:
7