Using The Appliance; Brushing Instructions - Philips Sonicare FlexCare+ 900+ Serie Manual De Instrucciones

12
English
The flashing light of the battery level indicator indicates that the
toothbrush is charging. (Fig. 3)
- 1 solid green LED indicates that the toothbrush is 34-66%
charged.
- 2 solid green LEDs indicate that the toothbrush is 67-94%
charged.
- 3 solid green LEDs indicate that the toothbrush is fully charged.
Note: If the battery charge of your Philips Sonicare is low, you hear 3
beeps and 1 LED of the recharge gauge flashes yellow for 30 seconds
after completing the brushing cycle.
Note: To keep the battery fully charged at all times, you may keep
your Philips Sonicare on the charger when not in use. Once the
Philips Sonicare is fully charged, the charger draws minimal energy
from the wall socket.
Note: It takes at least 24 hours to fully charge the battery.

Using the appliance

Brushing instructions

1 Wet the bristles (Fig. 4) and apply a small amount of toothpaste
(Fig. 5). (Fig. 4)
2 Place the toothbrush bristles against the teeth at a slight angle (45
degrees), pressing firmly to make the bristles reach the gumline or
slightly beneath the gumline. A change in vibration (and a slight
change in sound) alerts you when you apply too much pressure
while brushing. (Fig. 6)
Note: Keep the center of the brush in contact with the teeth at all
times.
3 Press the power on/off button to switch on the Philips Sonicare.
(Fig. 7)
4 Apply light pressure to maximize Philips Sonicare's effectiveness
and let the Philips Sonicare toothbrush do the brushing for you.
Do not scrub.