Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Zużyte narzędzia są surowcami wtórnymi - nie wolno wyrzucać
ich do pojemników na odpady domowe, ponieważ zawierają
substancje niebezpieczne dla zdrowia ludzkiego i środowiska!
Prosimy o aktywną pomoc w oszczędnym gospodarowaniu za-
sobami naturalnymi i ochronie środowiska naturalnego przez
przekazanie zużytego urządzenia do punktu składowania zu-
żytych urządzeń. Aby ograniczyć ilość usuwanych odpadów
konieczne jest ich ponowne użycie, recykling lub odzysk w
innej formie.
I N S T R U K C J A
10
PL
TOOL CHARACTERISTICS
The pneumatic set 3 in 1 is a tool which uses compressed air
under appropriate pressure to operate. The set consists of a
drive housing to which working attachments in the form of a
pneumatic ratchet, a straight tool grinder or an angle tool grind-
er can be attached by means of a quick coupling, without the
use of any tools. If the pneumatic ratchet drill is used, screws
can be screwed down and unscrewed, especially where high
torque is required, with socket wrenches attached to the carri-
er. When using the tool grinder, it is possible to grind and cut
with the appropriate accessories attached to the grinder chuck.
Proper, reliable and safe operation of the tool depends on ap-
propriate use, that is why you should
Read and keep this entire manual before the fi rst use of
the tool.
The supplier shall not be held liable for any damage or injury
resulting from improper use of the tool, failure to observe the
safety regulations and recommendations of this manual. Use
of the tool for purposes other than those for which it was in-
tended shall cause the loss of the user's rights to the warranty,
as well as under inconsistencies with the agreement.
ACCESSORIES
The set includes a drive housing, a pneumatic ratchet drill at-
tachment, a straight tool grinder and a tool angle grinder, a
connector that allows you to connect the tool to the pneumatic
system and wrenches to mount accessories in the tool grinder
chuck.
TECHNICAL DATA
Parameter
Catalogue No.
Drive housing weight
Attachment weight: ratchet
Attachment weight: straight grinder
Attachment weight: angle grinder
Diameter of air connector (PT)
Diameter of air supply hose (internal)
Pneumatic ratchet drill rotations
Maximum torque
Carrier size
Straight grinder rotations
Tool chuck diameter
Max.diameter of accessories
Angle grinder rotations
Tool chuck diameter
Max.diameter of accessories
Max. work pressure
Required air fl ow (at 0.63 MPa)
Sound pressure L
pA
Sound power L
wA
Vibrations (ISO 28927-2 / ISO 28927-12)
GENERAL SAFETY CONDITIONS
WARNING! When operating a pneumatic tool, it is recom-
O R Y G I N A L N A
GB
Unit
Value
YT-09860
0.63
[kg]
0.74
[kg]
0.15
[kg]
0.27
[mm / "]
6.3 / 1/4
[mm / "]
10 / 3/8
-1
]
180
85
[mm / "]
12.5 / 1/2
[min
]
18,000
-1
6
[mm]
50
[min
-1
]
15,000
[mm]
6
[mm]
50
0.63
113
[dB(A)]
88 ± 3
99 ± 3
2
]
3.95 ± 1.5
Tabla de contenido
