What If There Are Problems; Replacement Parts And Wearing Parts; Technical Data - Beurer ELLE MPE 38 Manual De Instrucciones

Important
Only insert UV-9W-L type fluorescent tubes into the device.
To replace the fluorescent tubes, follow the steps contained in section "3. Initial use".
Cleaning
Warning
Before beginning cleaning, pull the mains plug out of the socket!
• Clean the base plate after each use.
• Clean the surface of the device and the base plate carefully using a slightly damp cloth only.
• Do not use any cleaning agents or solvents.

6. What if there are problems?

Problem
Device will not switch
on.
UV nail gel does not dry. Treatment time with UV light too short. Set a longer UV light treatment time.
UV fluorescent tube
does not light up.

7. Replacement parts and wearing parts

Replacement parts and wearing parts are available from the corresponding service address (according to the
service address list). Please state the corresponding order number.
Designation
UV fluorescent tubes, 4 units
8. Disposal
Observe the local regulations for material disposal. Dispose of the unit in accordance with EC Directive
2002/96/EC – WEEE (Waste Electrical and Electronic Equipment). If you have any questions, please
contact the local authorities responsible for waste disposal.

9. Technical data

Model no.
Dimensions
Weight
Power supply
Nominal power
Permissible storage conditions
Number of UV lamps
UV lamp type
UV type of device
Switch-off times
Possible cause
Mains plug not plugged in.
No voltage at mains socket.
UV fluorescent tube not correctly
inserted.
UV fluorescent tube faulty.
Item number and/or order number
163.290
MPE 38
L 220 x W 210 x H 100 mm
1610 g (including UV fluorescent tubes)
230 V, ~ 50 Hz
36 W
Store in a clean and dry place
4
UV-9 W-L 365 nm, 9 W
UV-A lamp type 3
120 seconds, continuous operation
Solution
Insert the mains plug into the socket.
Check your fusebox.
Check that the UV fluorescent tube has
been correctly inserted.
Insert a new UV fluorescent tube.
10