DeWalt DCD791 Manual De Instrucciones página 14

3. Insert the accessory about 3/4" (19 mm) into the chuck and
tighten securely by rotating the chuck sleeve clockwise with one
hand while holding the tool with the other. Your tool is equipped
with an automatic spindle lock mechanism. This allows you to
open and close the chuck with one hand.
FIG. 4 FIG. 5
F
Be sure to tighten chuck with one hand on the chuck sleeve and one
hand holding the tool for maximum tightness.
To release the accessory, repeat steps 1 and 2 above.
Belt Hook and Bit Clip
(Optional Accessory) (Fig. 2)
WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
WARNING: To reduce the risk of serious personal injury,
ONLY use the tool's belt hook to hang the tool from a work
belt. DO NOT use the belt hook for tethering or securing the tool to
a person or object during use. DO NOT suspend tool overhead or
suspend objects from the belt hook.
WARNING: To reduce the risk of serious personal injury,
ensure the screw holding the belt hook is secure.
CAUTION: To reduce the risk of personal injury or damage,
DO NOT use the belt hook to hang the drill while using as a
spotlight.
FIG. 6 IMPORTANT: When attaching or replacing the belt hook or bit clip,
use only the screw (H) that is provided. Be sure to securely tighten
the screw.
The belt hook (G) and bit clip (I) can be attached to either side of the
tool using only the screw (H) provided, to accommodate left- or right-
handed users. If the hook or bit clip is not desired at all, it can be
removed from the tool.
To move belt hook or bit clip, remove the screw (H) that holds it in
place then reassemble on the opposite side. Be sure to securely
tighten the screw.
OPERATION
WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. 7)
NOTE: For best results,
make sure your battery
pack is fully charged.
To install the battery pack
(K) into the tool handle,
align the battery pack with
the rails inside the tool's
handle and slide it into the
12
FIG. 7
K
J