Display Light Bulb Replacement; Accessories; Temperature Indicating Display (Tid) - Hatco GLO-RAY Manual Del Usuario

GENERAL
Hatco Glo-Ray Pizza Warmers are designed for maximum
durability and performance, with minimum maintenance.
WARNING
To avoid any injury, turn the power switches OFF, unplug
the unit from the power source and allow to cool before
performing any maintenance.
WARNING
To avoid electrical shock or personal injury, do not steam clean
or use excessive water on the unit.
WARNING
Unit is not waterproof. DO NOT submerge in water. Do not
operate if it has been submerged in water.
CLEANING
CAUTION
Use only non-abrasive cleaners. Abrasive cleaners could scratch
the finish marring its appearance and making it susceptible
to dirt accumulation.
To preserve the bright finish of the Glo-Ray Pizza Warmer,
it is recommended that the exterior and interior surfaces be wiped
daily with a damp cloth. Stubborn stains may be removed with
a good non-abrasive cleaner. Hard to reach areas should be cleaned
with a small brush and mild soap.
Clean the glass sides using a common glass cleaner.

DISPLAY LIGHT BULB REPLACEMENT

The display light is an incandescent light bulb which illuminated
the warming area. The bulb has a special coating to guard against
injury and food contamination in the event of breakage.
1. To replace a light bulb, disconnect the power supply and wait
until the unit has cooled.
2. Light bulbs have a threaded base. Unscrew the light bulb from
the unit and replace it with a new specially coated incandescent
light bulb.
TEMPERATURE INDICATING
DISPLAY (TID) - SEE
Units maybe equipped with temperature indicating displays which
show the current base temperature of each shelf.
10
NOTE: Hatco shatter-resistant light bulbs meet N.S.F. standards
for food holding and display areas. For 120, 120/208 and 120/240
volt applications, use Hatco part #02.30.043.00. For 220-230
or 230-240 volt applications, use Hatco part #02.30.058.00.
Only light bulbs which meet or exceed N.S.F. standards,
specifically designed for food holding areas must be used.
Breakage of light bulbs not specially coated could result
in personal injury and/or food contamination.
If service is required on this unit, contact your Authorized
Hatco Service Agent, or contact the Hatco Service Department
at 800-558-0607 or 414-671-6350; fax 800-690-2966
or International fax 414-671-3976.
This product has no "user" serviceable parts. To avoid damage
to the unit or injury to personnel, use only Authorized Hatco
Service Agents and Genuine Hatco Replacement Parts when
service is required.
Genuine Hatco Replacement Parts are specified to operate
safely in the environments in which they are used. Some
aftermarket or generic replacement parts do not have
the characteristics that will allow them to operate safely
in Hatco equipment. It is essential to use Hatco Replacement
Parts when repairing Hatco equipment. Failure to use Hatco
Replacement Parts may subject operators of the equipment
to hazardous electrical voltage, resulting in electrical shock
or burn.
NOTE: This accessory is factory installed only, not available
for retrofit.
8
MAINTENANCE
WARNING
WARNING
WARNING
WARNING

ACCESSORIES

Form No. GRPWSCEM-0702