Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Gear I: smaller rotational speed range, larger
torque values.
Gear II: larger rotational speed, smaller torque
values.
Set the gear shift switch in the appropriate
position according to the type of work to be
performed. If the switch cannot be moved, turn
the spindle slightly.
Never use the gear shift switch when the
drill/driver is in operation. This could result in
damage to the power tool.
Drilling with the power tool at low rotational
speeds may result in overheating of the motor.
Make regular breaks in your work or allow the
device to work at maximum rotational speed
without load for about 3 minutes.
HOOK
The drill/driver has a practical hook (6) that can
be used for example to hang the power tool
on a fitter's belt during work at heights.
SERVICE AND MAINTENANCE
MAINTENANCE AND STORAGE
• The power tool should be cleaned after each
use.
• Do not use water or other liquids to clean the
power tool.
• The driver/drill should be cleaned with a piece
of dry cloth or with a jet of compressed air at
low pressure.
• Do not use any cleaning agents or solvents as
they may damage the plastic parts.
• Clean the ventilation slots in the motor
housing regularly so as to prevent overheating
of the power tool.
• In the event of excessive sparking of the
commutator, have the condition of the carbon
brushes of the motor checked by a qualified
person.
• Always store the drill/driver in a dry place
inaccessible to children.
REPLACEMENT OF THE CHUCK
The chuck is screwed onto the thread of the
spindle and also secured with a screw.
• Set the rotation direction switch (5) in the
central position.
• Open the jaws of the chuck (1) and unscrew
the fixing screw (left-hand thread) (fig. H).
• Put an Allen key in the chuck and gently tap
the other end of the key.
• Unscrew the chuck.
• In order to install the chuck, perform the above
actions in a reverse order.
Any and all defects must be removed by service
companies authorized by the manufacturer.
TECHNICAL PARAMETERS
RATING DATA
Cordless drill/driver
Parameter
Battery voltage
Battery type
Battery capacity
Range of rotational speed
in the idle gear
Range of chuck
Range of torque control
Max. torque (soft drive)
Max. torque (hard drive)
Protection class
Weight
Year of manufacture
Parameter
Supply voltage
Supply current frequency
Charging voltage
Max. charging current
Charging time
Protection class
18
Value
18 V DC
Li-Ion
1500 mAh
0-400/0-1100
-1
min
1-10 mm
1-20 plus drilling
30 Nm
48 Nm
III
1,51 kg
2019
Charger
Value
230 V AC
50 Hz
21 V DC
1500 mA
1 h
II
Tabla de contenido
