English; Important; Care Instructions; Product Servicing - IKEA TRADFRI Guia De Inicio Rapido

English

HOW TO STEER YOUR LIGHTING
The switch on your power supply cord will make
it possible to turn ON/OFF all products connected
to the TRÅDFRI driver, but if you want to dim or
connect your products to IKEA Smart lighting
products, you need to buy a separate TRÅDFRI
steering device (e.g. a remote control).
The TRÅDFRI steering device needs to be paired
with your TRÅDFRI driver/s. If you have more
than one (1) driver you can pair each one with the
steering device, so that the entire combination can
be turned ON/OFF or dimmed at the same time.
Depending on how easy it will be to access
the driver please consider to pair the TRÅDFRI
driver/s with your steering device before the final
placement of the driver/s and cords.
PAIRING A STEERING DEVICE TO YOUR DRIVER
1. Connect at least one (1) product to the driver
before you begin the pairing. Make sure that
the power supply cord is connected to a power
socket and that the switch on the cord set is
turned ON.
2. Locate the pairing symbol on the driver. Hold the
steering device close to the pairing symbol (no
more than 5 cm away).
3. Press and hold the pairing button on the steering
device for at least 10 seconds. A red light will
shine steadily on the steering device.
The product connected to the driver will begin to
dim and flash one time to indicate that the driver
is being paired to the steering device.
HOW TO FACTORY RESET YOUR DRIVER
If the driver does not respond or if you want to
un-pair the driver from a steering device you might
have to make a factory reset. The driver is forced to
factory reset by carefully inserting a paper clip end
or similar in the small hole (marked RESET) in the
driver enclosure and applying a slight pressure.

IMPORTANT!

• The driver is for indoor use only and can be used
in temperatures ranging from 5ºC to 45 ºC.
• Do not leave the driver in direct sunlight or near
any heat source, as it may overheat.
• Do not subject the driver to wet, moist or
excessively dusty environments as this may
cause damage.
• The declared radio range between the driver
and the steering device is measured in open
air. Different building materials and placement
of the units can affect the wireless connectivity
range.

CARE INSTRUCTIONS

To clean the driver, wipe with a dry soft cloth.
Never use abrasive cleaners or chemical solvents as
this can damage the product.

PRODUCT SERVICING

Do not attempt to repair this product yourself, as
opening or removing covers may expose you to
dangerous voltage points or other risks.
TECHNICAL DATA 10W
Type: ICPSHC24-10CN-IL-1
Input voltage: 220-240Vac, 50/60Hz
Output voltage: 24.0Vdc
Max output power: 10.0W
For indoor use only
Radio range: 10 m in open air.
Operating frequency: 2405-2480 MHz
Output power: 14 dBm
Manufacturer: IKEA of Sweden AB
Address:
Box 702, SE-343 81 Älmhult, SWEDEN
The crossed-out wheeled bin symbol indicates that
the item should be disposed of separately from
household waste. The item should be handed in for
recycling in accordance with local environmental
regulations for waste disposal. By separating a
marked item from household waste, you will help
reduce the volume of waste sent to incinerators or
land-fill and minimize any potential negative impact
on human health and the environment. For more
information, please contact your IKEA store.
4