Standard Stuffer Assembly Instructions - Weston BUTCHER Serie Manual Del Usuario

STANDARD STUFFER ASSEMBLY INSTRUCTIONS

w WARNING Entanglement Hazard. To avoid serious or fatal injury,
never reach into grinder feed chute. Always use stomper. Never operate
without tray in place. Secure long hair and loose clothing before use.
Disconnect power before assembling. Always read instructions.
1. Insert the Head into the Gear
Housing with the feed chute of the
Head facing straight up. You will need
to line up the slot in the Head with the
Pin inside the Gear Housing. Be sure
the Head is seated fully into the Gear
Housing. (FIGURE 5)
2. Tighten the Head Locking Knob to
lock the Head into place.
3. Insert the Auger into the Head
(FIGURE 6). Align the Auger Splines
with the Drive Shaft of the Grinder.
NOTE: Periodically inspect the
Auger Bearing for wear. If the Auger
Bearing has excessive wear, replace
it to prevent head damage.
4. Slide the Stuffing Star over the
round portion of the Auger Pin.
5. Slide one of the Stuffing
Funnels through the Flange and
place it through the Front Ring
Nut.
6. Install the Front Ring Nut, DO NOT
OVERTIGHTEN. Turn the Front Ring Nut until it makes contact with the
Flange, then make 1/4 turn more to
tighten into place.
7. Insert the neck of the Tray into the
Feed Chute (FIGURE 7).
8. NEVER operate Grinder without
the Tray secured in place (FIGURE 7).
REFER TO "STUFFING
INSTRUCTIONS"
Slot in Head
Feed
Chute
Head
Gear Housing
Head Locking
Auger Splines
Auger
Auger Pin
Front Ring
Nut
Tray
Neck
Feed
Chute
Head
FIGURE 5
Knob
FIGURE 6
Head
FIGURE 7
11