Chime Volume Adjustment - Vimar ELVOX TAB Instrucciones Usuario

handset) to adjust the desired level. A beep is
emitted on reaching the maximum or minimum
level.
It is adjusted during a conversation.
User configurations
These operations are to be done with the in-
door unit on standby and the handset hung
up.
Selecting call tunes
You can select the chimes from among 10 call
tunes
Button 1 selects the ENTRANCE PANEL CALL
tune.
Button 2 selects the INTERCOM CALL tune.
Button 3 is used to select the LANDING CALL
tune (with specific electronic module).
1) Press and hold down the
until the button starts blinking accompanied
by an audible warning.
2) Press button or
will start playing the last tune in memory.
3) Repeatedly press button or
the kind of tune you want.
4) Press the button to save the tune or wait
15s. At the end of configuration, the blinking
button goes out.

Chime volume adjustment

The chime volume can be set to 10 levels.
1) Press and hold down the
until the button starts blinking accom-
panied by an audible warning.
2) Press button
increase the chime volume. Each time the
buttons are pressed the volume changes by
one level.
3) After selecting the required volume, press
button to save the tune or wait 15s. At
the end of configuration, the
EN
button (for 2 s)
or and the indoor unit
or to select
button (for 2 s)
to decrease or
button
stops blinking.
Muting the chime (User Away func-
tion)
To mute the chime, press the
hold it down (approximately 2s). Deactivation
is confirmed with a "low-pitched" tone and the
button lighting up with a steady light. Chime
reactivation is signalled by a "high-pitched"
tone and the
user away, the indoor unit is able to keep up
to 4 missed calls in memory by blinking the
button. Saving to memory consists of one flash
per missed call. The signalling takes place with
flashes every 10s. When the chime is restored
the counter is reset. This function can be acti-
vated with the indoor unit at rest.
Maintenance
Clean using a soft cloth. Do not pour water onto
the appliance and do not use any type of chem-
ical product.
Swiping your palm over the keyboard locks the
buttons and all the LEDs will blink for 5 sec-
onds. The 5s timeout is renewed every time a
button is touched. After the 5s timeout the mon-
itor will emit another warning beep.
Warnings for the user
Do not open or tamper with the appliance.
In the event of trouble, call in specialized
personnel.
to
button and
button going out. With the
9