Sony XAV-7W Instalación / Conexiones página 8

When removing front panel plate
Front panel
plate 4
Do not throw away the front panel plate,
since it will be needed when you change
the car you install the unit.
For details, see "Removing the Front
Panel Plate". (page 17).
Note
• Do not press the front panel buttons of
the unit during installation and do not
apply strong force.
• Do not place any objects on top of the
unit.
8
Toyota cars (illustration shows an example for a Toyota car)
Align the brackets of the factory-installed car stereo with the
mounting holes marked "T" on the side of the Media Center main
unit, and use the supplied screws to fasten the brackets. For
Toyota cars, the supplied screws 6 should be used.
Screws of factory-
installed car stereo
bracket
Nissan cars
Align the brackets of the factory-installed car stereo with the
mounting holes marked "N" on the side of the Media Center
main unit, and use the supplied pan-head screws 6 to fasten the
brackets.
Screws of factory-
installed car stereo
bracket
* Be sure to use only the supplied pan-head screws 6 for
installation. If any other screws are used, make sure they
conform to the requirements shown below.
Using longer screws can cause internal damage to the unit.
6 mm
Damage can also occur if the screws are used directly on the
unit without the brackets of the factory-installed car stereo.
6
6
5 mm
Bracket of
factory-installed
car stereo
Bracket of
factory-installed
car stereo