Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2
MAKE WATER SUPPLY CONNECTIONS
• Turn off hot and cold water supplies before beginning.
• Connect FLEXIBLE SUPPLY HOSES (1, 2) directly to wall
supplies. Connection on fitting supplies are 3/8"
compression. Connect left supply hose (Red Stripe) to Hot
wall supply. Connect right supply hose (Blue Stripe) to Cold
wall supply. Use adjustable wrench to tighten connections.
Do not over tighten.
*
Faucet supplies are 32 " long from faucet base.
• Note: If additional supply length is required, installer
must purchase additional parts separately.
• Important: If SUPPLY HOSES (1, 2) are too long,
loop as illustrated to avoid kinking.
3
CONNECT SPRAY HOSE AND INSTALL WEIGHTS
• Push the SPRAY HOSE END (1) into the HOSE
CONNECTOR (2) and slide down the LOCKING
COLLAR (3) until it snaps into place.
• With HAND SPRAY (4) seated in SPOUT (5), install
WEIGHT (6) at labeled area on HOSE (7), secure
with SCREW (8).
4
TEST INSTALLED FAUCET
• Turn ON water at main supply.
• With HANDLE (1) in "off" position, unthread SPRAY (3) from HOSE (2).
• Operate handle back to front, in COLD and HOT positions, to flush water
lines thoroughly.
• Replace SPRAY (3) onto HOSE (2).
3
REMOVE
SPRAY OPERATION
• With FAUCET on, press TOGGLE BUTTON (4) on SPRAY (3) to switch
from stream to spray.
HOT
OFF
• Press and hold PAUSE BUTTON (5) to temporarily stop flow from SPRAY
ON
(3). Release PAUSE BUTTON (5) to resume flow from SPRAY (3).
COLD
1
5
4
8
6
7
3
- 2 -
BLUE
RED
STRIPE
STRIPE
2
COLD
1
HOT
2
1
5
STREAM (AERATOR)
4
SPRAY
3
M985011 (3/19)
Tabla de contenido
