Timberpro M2600-3 Manual Del Propietário página 22

7. Operation
Adjust the pump as follows:
1. Stop the engine and make sure the stop switch is in
the OFF position.
2. Place the unit on its side with the oil reservoir up.
(1) Oil tank (2) Chain cover
IMPORTANT
The oil flow adjusting screw must be pressed in slightly
in order to turn. Failure to do so could damage the
pump and screw.
3. With a screwdriver, push in on the oil flow rate adjust-
ing screw and turn in the desired direction (there are
three incremental settings):
(a) Clockwise-decrease lubrication
(b) Counter clockwise-increase lubrication
(c) Middle
WARNING
• Always wear work gloves made of leather or some
other sturdy material when using the polesaw.
• Falling branches may fall onto the face or into the
eyes, resulting in injuries, scratches, and cuts, and
for this reason you should always be sure to wear
a helmet and face protector when using your
polesaw.
GB 20