Notes On Overhaul; Notes On Guarantee And Repair; Troubleshooting - Seiko 6R20 Instrucciones

NOTES ON OVERHAUL

The watch is a precision device with a lot of moving parts lubricated with
●
special oils. If the parts run short of oil or get worn out, the watch may lose
time or stop its operation. In such a case, have the watch overhauled.

NOTES ON GUARANTEE AND REPAIR

Please contact the retailer the watch was purchased from or SEIKO CUSTOMER
●
SERVICE CENTER for repair or overhaul.
Within the guarantee period, please present the certificate of guarantee to
●
receive repair services.
Guarantee coverage is provided in the certificate of guarantee. Please read
●
carefully and retain it.
20

TROUBLESHOOTING

Problem Possible causes
The watch stops The power supplied by
operating. the mainspring has been
consumed.
Even though you wear The watch is worn on your
the watch every day, wrist only for a short period
the power reserve indicator of time, or the amount of arm
does not move up. movement is small.
The watch gains/loses The watch has been left
temporarily. in extremely high or low
temperatures for a long time.
The watch was brought into
close contact with a magnetic
object.
You dropped the watch, hit it against
a hard surface or wore it while
playing active sports. The watch
was exposed to strong vibrations.
The watch has not been
overhauled for more than 3 years.
The day and date change AM/PM is not properly set.
at 12 o'clock noon.
The glass is blurred and the Water got inside the watch due to
blur persists for a long time. the deterioration of the gasket, etc.
* For the solution of troubles other than listed above, contact the retailer from whom the watch was purchased.
Solutions
Turn the crown or swing the watch to wind it up. The
watch will start operating. If the watch does not start,
consult the retailer from whom the watch was purchased.
Wear the watch for an extended period of time, or
when taking off the watch, turn the crown to wind the
mainspring if the remaining power shown by the power
reserve indicator is not sufficient for the next use.
Normal accuracy will resume when the watch
returns to normal temperature.
Normal accuracy will resume when the watch is
kept away from close contact with the magnetic
source. If this condition persists, consult the
retailer from whom the watch was purchased.
Normal accuracy will not resume. Consult the
retailer from whom the watch was purchased.
Consult the retailer from whom the watch was
purchased.
Advance the hands by 12 hours.
Consult the retailer from whom the watch was
purchased.
21