Installing With Support En; Installing Without Support En; Fastening The V-Block En - Abicor Binzel RS-LCi Instructivo De Servicio

BRS-LCi
4 screws M8
1
Complete V-block
2
Cleaning station
3
Putting into operation
Fig. 4
6.1 Installing with support
 See Fig. 4 Putting into operation on page EN-9
1 Fasten the support (9) on a vibration-free working surface in the work area of the robot by means of four
screws (8).
2 Position cleaning station (3) with two cylindrical pins (12) on the support (9) and fix it with four screws
(1).
3 Fasten collecting tray (11) to the support (9) by means of two screws (10).
6.2 Installing without support
 See Fig. 4 Putting into operation on page EN-9
 See 2.3 Technical Data on page EN-4
1 Position cleaning station (3) with two cylindrical pins (12) on a vibration-free mounting surface and fix
it with four screws (1).
2 Fasten collecting tray (11) below the motor by means of two screws (10).
3 Fasten drain of collecting tray (11) with a hose (ø= 8mm) to a suitable collecting container. If none is
used, you must seal the drain (thread G 1/8").
4 Fasten bottle holder (7) in the vicinity of the cleaning station.
6.3 Fastening the V-block
 See Fig. 4 Putting into operation on page EN-9
1 Screw the V-block (4) into the clamping device (6) from above.
2 Screw in the cylinder screw (5).
1 2
12
11
10
9 8
V-block
4
Cylinder screw M5x200
5
Clamping device
6
3 4
5
6
7
Bottle holder
7
4 screws
8
Support
9
6 Putting into operation
10 2screws
11 Collecting tray
ø
8 mm
12 2 Cylinder bolt
EN - 9