Setup Instructions - Kathrein DVB-S(2)-COFDM Manual Del Usuario

Note: The most up-to-date version of these user instructions can be found on the Kathrein homepage under:
"www.kathrein.de" → Service → Operating instructions

Setup instructions

The DVB-S(2) trans-modulator/multiplexer (2 x QPSK/8PSK on COFDM) is set up using the controller on the base unit UFG 404 or
UFG 412 or UFG 412/R.
Required controller software version: from version V9.40
For setup, connect the controller to the module. The buttons listed below refer to the controller (see also the user instructions for the
UFG 404, etc. base units and the UFG 300 controller).
Note: The settings and numerical values shown below are intended as an example and do not necessarily match the
delivery status.
Select the desired parameter using the "<" and ">" buttons.
The selected parameter fl ashes in the display.
The setting is performed using the "+" and "-" buttons and where necessary using the "Change setting mode" button
The sub-menus are activated and deactivated by pressing the "Sub-menu" button
Finally, press "M" to save the setting in the module.
Note: If the controller is disconnected from the module by pressing the "M" button without saving the settings,
the settings originally stored in the module are reactivated.
The following representation shows the appearance of the display after plugging in the controller.
Note: The indicator ("*") fl ashes at top right during channel unit initialisation.
E1 1236
27.500 MS/s
Outp. * S21
8 MHz
Main menu (all symbols shown)
■
Displays
"*" Left of "TP":
Indicates "desired operating mode not yet reached", displayed permanently in case of error.
If the indicator is fl ashing, the channel unit cannot operate properly.
Reasons for this include:
- Input frequency or symbol rate set incorrectly
- No input signal
Right of "Outp.":
The channel unit output is switched off
MHz
*
3/4 QPSK
306.00 MHz
QAM64
TP
2 / 14
.
.