Kathrein DVB-S(2)-COFDM Manual Del Usuario página 22

Note: In PRBS mode you can set the COFMD parameter guard interval and code rate.
The CW mode can be used for output level measurement.
Outp. S21
----
Main menu (display in the CW mode)
1.12 Selecting the COFDM parameters
In the PRBS mode sub-menu you can set the COFMD parameter guard interval and code rate. The parameters can only be selected
if SAT-Sig or PRBS operating mode has been selected.
The output signal parameters are selected using the "<" and ">" buttons and adjusted using the "+" and "-" buttons.
E1 1236
27.500 MS/s
Outp. S21
8 MHz
The following settings are available:
Guard 1/4, 1/8, 1/16, 1/32
Code rate 1/2, 2/3, 3/4, 5/6, 7/8
1.13 Transport stream processor: Channel multiplex
Note: The Electronic Programme Guide (EPG) shows only the programmes that are available on the E1 input tuner.
This should be recognised when scheduling.
E1 1236
27.500 MS/s
Outp. S21
8 MHz
The setting of the channel multiplex "fi lter" is performed in the "TP" (transport stream processor) sub-menu.
The "TP" transport stream processor is selected using the "<" and ">" buttons and the sub-menu is called up using the "Sub-menu"
button. This sub-menu can be exited only when the cursor is on the "Back" parameter. To do this, use the "<" and ">" buttons to select the
parameters "on" and "off" and press the "Sub-menu" button
306.00
MHz
3/4
306.00
QAM64
Main Menu
Lower values permit higher data rates
Higher values permit higher data rates at the cost of reduced error protection
MHz P
3/4
306.00
QAM64
Main Menu
***
CW
Mode
MHz
"COFDM mode" sub-menu (for setting CW)
TP ***
QPSK Mode
MHz Guard
Code rate
***
TP
QPSK Filter
MHz IDs
Back
to return to the main menu.
8 / 14
UFO333MX
CW
UFO333MX
SAT Sig
1/32
5/6
"QAM stage" sub-menu
UFO333MX
0% /
"Transport stream processor" sub-menu
***
***
***
0%