Intended Use; General Safety Instructions; Transportation And Storage - Kathrein UFOmini 87 Manual Del Usuario

Intended Use

The UFO 87 is used for transmodulation of DVB signals. The latest triple-tuner technology makes it possible to receive
up to eight DVB-S(2)/ -T(2)/ -C transponders. These can be received from the four Sat-IF inputs with DiSEqC
ality and the terrestrial/cable input in any combination. The UFO 87 delivers up to eight individually configurable output
channels conforming to DVB-C.
The highly efficient baseband signal processing offers channel filter, NIT, CAT and LCN functionality. The configuration
is carried out by means of the USW 800 management software over an IP interface. An optional cascading of two units
(UFO 87 or/and UFO 87/CI) is possible via a USB connection.
The unit is intended exclusively for the application in the UFG 810 as well as in satellite, cable or antenna reception
systems. Any other use of failure to comply with these instructions will result in voiding of the guarantee or warranty.

General safety instructions

● The device can be connected to the power supply and disconnected from it only by means of the power plug. Make
sure that the connected power plug is always freely accessible and easy to reach.
● If the casing is damaged, do not connect the device to the power supply.
● If the device and/or the cables connected to it are damaged, immediately disconnect the system from the power
supply. Do not switch the system on again until
– the device has been repaired by the dealer or manufacturer,
– and the cables connected have been repaired by a competent person.
● Do not open the casing and do not modify the device. Otherwise the guarantee and warranty will become void.
● Never cover the cooling ribs or the air circulation openings.
● Do not modify, remove or disfigure the notices and markings applied by the manufacturer.
● Refer to the manufacturer's documentation before connecting external components other than those described
in this document (such as computers, network components). Incorrectly connected components can damage the
device.
● Refer to the current issue of the safety requirements EN 60728-11 and EN 60065.
● Disconnect the device from the power supply before performing mechanical work on the system.
WARNING
Risk of burns from hot surfaces!
In the event of a defect the heat sink of the unit may exceed 70 °C.
► Do not touch the heat sink when the device is in operation or has recently been in operation.
Note
In the event of overheating, the device will shut down automatically and after it has cooled down will switch
on again automatically.

Transportation and Storage

► Transport and storage the unit in its original packaging.
► Protect the unit against dust, dirt, moisture and direct sunlight.
► Transport and store the unit in the permissible temperature range from –25 to +70 °C. Make sure there is no water
condensation bildup.
2 / 8
function-
TM