Operation; Care And Cleaning; Troubleshooting - Glacier bay FS1A9277CP Guía De Instalación Y Cuidado

Operation

1
Flushing and checking for leaks
IMPORTANT: After installation is complete, remove the
aerator to flush the water lines. Do not lose the gasket in
the aerator.
□
Ensure the handle is in the off position. Turn on the
water supply and check for leaks. If you discover
any leaks, check your connections to ensure they
are installed properly.
□
Remove the aerator (B) and housing (if applicable).
Turn on the hot and cold handles to allow the water
to run for at least one minute. This flushes away
any debris that could cause damage to internal
parts.
□
Turn off the water and reinstall the aerator (B) and
housing (if applicable).

Care and Cleaning

□
To clean, wipe down with a damp cloth and towel dry.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.

Troubleshooting

NOTE: Refer to the service parts section in this manual
for a detailed drawing showing the location of the parts
listed below.
Problem
There are leaks from the
handle.
The aerator leaks or has a
reduced water flow.
The sink drain at the base of
the sink is leaking.
The water will not shut off
completely.
Possible Cause
□
The bonnet nut is loose.
□
The O-ring on the cartridge is
dirty or damaged.
□
The aerator is dirty or misfitted.
□
The cartridge may be clogged.
□
The sink surface is rough or
irregular.
□
The cartridge bonnet nut
is loose or cartridge is not
positioned correctly.
□
The cartridge is damaged.
Solution
□
Tighten the bonnet nut.
□
Clean or replace the O-ring.
□
Remove the aerator and check for
debris.
□
Remove the cartridge and check for
debris.
□
Ensure the aerator is properly
installed.
□
Retighten and test for leaks.
□
Reinstall the cartridge after cleaning
and tighten the bonnet nut.
□
If the problem still exists, replace the
cartridge.
8
A
B