Installation (continued)
8
Installing the lift rod
□
Insert the lift rod (W) through the spout
assembly (A) and into the strap (V).
□
Tighten the screw (U).
Operation
1
Flushing and checking for leaks
IMPORTANT: After installation is complete, remove the
aerator to ush the water lines.
□
Turn on the water supply and allow both hot
and cold water to run for at least one minute
each. This ushes away any debris that could
cause damage to internal parts.
□
While the water is running, check for leaks.
□
Turn off the water and replace the aerator.
8
A
W
U
V