Operation; Operating The Sensor - Glacier bay HD67685W-5004 Guía De Uso Y Mantenimiento

Operation

1
Flushing and checking for leaks
IMPORTANT: After installation is complete, remove the
aerator from the faucet (A) to ush the water lines. Do not
lose the gasket (1) in the aerator.
□
Turn on the water supply to check for leaks.
If you discover any leaks, check your connections
to ensure they are installed properly.
□
Turn the water on by activating the sensor (2)
by waving your hand and allow both hot and
cold water to run for at least one minute each.
This ushes away any debris that could cause
damage to internal parts.
□
Turn off the water and reinstall the aerator.
2

Operating the sensor

NOTE: The handle only controls the water temperature.
Turn the water on and off with the wave of your hand.
□
Turn the water on by activating the sensor (1)
by waving your hand within 2-3/8 inches of
the sensor. When activating the sensor (1) by
waving your hand within 2-3/8 inches of the
sensor again, the water will turn off.
□
Pulling the handle towards yourself will turn
the water to cold. Pushing the handle away
from yourself will turn the water to hot.
□
If you are having trouble with the sensor,
please refer to the troubleshooting section.
NOTE: As a water saving feature, the water will turn off
automatically after 3 minutes of continuous ow.
0 1
min.
45
15
30
2
0
3
min.
45
30
1
2-3/8 in. Max
12
A
15
Cold
1
Hot