Transport And Storage Of Cordless Tools - Hilti SIW 9-A22 Manual De Instrucciones Original

8

Transport and storage of cordless tools

Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of
transport.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a
window pane.
▶ Store the tool and batteries in a place where they cannot be accessed
by children or unauthorized persons.
▶ Check the tool and batteries for damage before use after long periods of
storage.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
Trouble or fault
The power tool
doesn't start.
The control switch
cannot be pressed.
*2113609*
Possible cause
1 LED blinks: The bat-
tery is empty.
The battery is not fitted
correctly.
1 LED blinks: The bat-
tery is too hot or too
cold.
4 LEDs blink: The power
tool was overloaded
briefly.
The forward / reverse
selector switch is in the
middle position.
2113609
Action to be taken
▶ Remove the battery
and charge it.
▶ The battery must be
heard to engage.
Remove the battery
and refit it.
▶ Allow the battery to
cool down / warm
up to its working
temperature.
▶ Release the control
switch and then press
it again.
▶ Push the forward /
reverse switch to the
left or right.
English 13