Bosch 52314 Manual De Operación página 8

BM 2610916876 5/02 5/29/02
BLADE INSTALLATION AND REMOVAL
This jigsaw is equipped with the Bosch
"Clic" tooless blade changing system. This
system makes changing blades simple and
fast.
Insert the saw blade (teeth in cutting
direction) until it latches in the plunger. When
inserting the saw blade, the back of the
blade must rest in the groove of the guide
roller (Fig. 2).
Note: If the saw blade cannot be inserting
into the plunger, the slots of the blade holder
are not positioned as shown, push the blade
ejector lever briefly to the front and release.
To change the saw blade, push the ejector
lever to the center stop; this releases the
saw blade and it is ejected.
When changing the blade, tool should be
held so that the blade is safely ejected.
ATTACHING NON-MARRING OVERSHOE
Your tool is equipped with a protective
plastic overshoe that protects finer surfaces.
To attach, hook overshoe over front of metal
footplate and snap into place at rear of
footplate (Fig. 3).
ANTI-SPLINTER INSERT
To minimize splintering of the top surface of
the material being cut, place the anti-splinter
insert in the blade opening of the footplate,
or the non-marring overshoe.
Note: This insert will only work with blades
that have ground sides such as T301CD,
TB1B, T101D, and T101DP.
SWITCH LOCK
The switch lock is designed to prevent
accidental starts. To operate switch, press
the switch lock button with your thumb to the
unlock symbol. To lock the switch, press
the switch lock button to the lock
(Fig. 1).
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON" or
8:48 AM Page 8
Assembly
FIG. 2
EJECTOR
LEVER
PLUNGER
Operating Instructions
"OFF" by squeezing or releasing the trigger. The
speed can be adjusted from the minimum to
maximum nameplate SPM by the pressure you
apply to the trigger. Apply more pressure to
increase the speed and release pressure to
symbol decrease speed (Fig. 1).
When the trigger is released it activates the
electrical brake to stop the blade quickly. This
feature is especially useful when making
repetitive cuts.
-8-
GUIDE
ROLLER
BLADE
GUIDE
ROLLER
FOOTPLATE
ANTI-SPLINTER
INSERT
NON-MARRING
OVERSHOE
FIG. 3
BRAKE