Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Ñ
Supplied accessories for
installation
1
(M5 × 6 mm)
x6
3
(3 m)
x1
Ñ
Installation procedure
1) To prevent a short circuit, remove the key
from the ignition and disconnect the ¤
terminal of the battery.
2) Make the proper input and output wire
connections for each unit.
3) Connect the wiring harness connector to the
unit. See Wiring harness connector function
guide (P.47).
4) Install the unit in your car.
5) Reconnect the ¤ terminal of the battery.
6) Press the reset button.
2
(M5 × 8 mm)
x6
4
(2 m)
x1
Installing the unit
1 or 2
Car Bracket
Ñ
Microphone unit
1) Check the installation position of the
microphone (accessory 3).
2) Clean the installation surface.
3) Remove the separator of the microphone
(accessory 3), and stick the microphone to
the place shown below.
4) Wire the microphone cable up to the unit
with it secured at several positions using tape
or other desired method.
5) Adjust the direction of the microphone
(accessory 3) to the driver.
3
Fix a cable with a commercial item of tape.
NOTE
• Swap the clips if necessary.
Connection/Installation
1 or 2
English
45
Capítulos
Tabla de contenido
Solución de problemas
