Factory Reset - Ibanez MiMX30 Manual De Instrucciones

3. Saving the sound
Now we'll save the sound in the channel 1.
[1] Press and hold down the channel "1" button for 3 seconds or longer.
[2] Next we'll vary the sound a little bit and save it in the channel "2" bank to verify
the sound is saved.
 Turn down Treble control as figure shows.
 Then press and hold down the channel "2" for 3 seconds or longer. The channel
"2" button will blink a second after saved and light.
[3] Now you can compare the sound difference between the channel 1 and 2 and
find the new sounds are saved in those channels.
Next we'll play the guitar with a rhythm pattern.
4. Using rhythm patterns
This tutorial uses a Funk type rhythm pattern in rhythm bank 3.
[1] We'll select the rhythm bank at first.
 Press and hold down the ON/OFF switch for 3 seconds or longer.
 An activated rhythm bank now blinks.
 Click rhythm bank "3" button (same as the channel 3 button) and it will light.
 Turn up the RHYTHM volume as the figure below shows or desired.


[2] You can select a different rhythm pattern within the rhythm bank 3/FUNK by

5. Factory Reset

This section explains how to initialize the amp to the factory-set condition.
 While holding down the MANUAL switch, turn on the POWER switch.
 The MANUAL button will blink.
 Click the MANUAL switch in this state and all data will return to the factory-set


clicking "←" switch or "→" switch. You can change rhythm tempo by tapping the
TAP switch. To adjust the rhythm, follow the figure below.
 Run a rhythm  Change the rhythm
pattern pattern
condition.
* If you decide to cancel without resetting, operate any control other than the
MANUAL switch. You will exit factory reset mode.

 Change the rhythm
tempo
 
11