Electrical Connection; Wiring Details - SICK PBS Manual De Instrucciones

Operating Instructions

Electrical connection

Connect the instrument to earth via the pressure connection.
„
For power supply, use a circuit with energy limitation (EN/UL/IEC 61010-1, section 9.3)
„
with the following maximum values for the current: with L + = 35 V (DC): 4.0 A. Provide a
separate switch for the external power supply. Alternative for North America: The connec-
tion may also be made to „Class 2 Circuits" or „Class 2 Power Units" according to CEC
(Canadian Electrical Code) or NEC (National Electrical Code).
Zero-point adjustment: Check the zero point shown on the display during commissioning.
„
If, for installation reasons, an offset is displayed, this can be reset in programming mode
using the 0SET parameter.

Wiring details

Ingress Protection per
IEC 60 529
26 © SICK AG • Germany • All rights reserved • Subject to change without notice
7. Starting, operation
Circular connector M12x1, 4-pin
2 switching outputs or
1 switching output +
1 analogue output
Q1 1 = 4
L+ = 1 M = 3
C/Q1 = 4
IP 67
The ingress protection classes specified only apply while the pressure transmitter is connected
with female connectors that provide the corresponding ingress protection.
Circular connector M12x1, 5-pin
2 switching outputs + 1 analogue output
Q2 = 2 /
L+ = 1 M = 3
Q = 2
A
IP 67
PBS
Q1 = 4
Q2 = 2 Q = 5
C/Q1 = 4
A
8013154/UP90/2015-03-30