Periodic Maintenance; Tightening Torques; Troubleshooting; Storage - Chicago Pneumatic CP 4123 Instrucciones De Seguridad Y De Funcionamiento

Safety and operating instructions

Periodic maintenance

After each operating period of approximately 150
impact hours or twice a year the machine must be
dismantled and all parts be cleaned and checked.
This work must be performed by authorised staff,
trained for this task.

Tightening torques

A. Air inlet nipple: 50-60 lbf/ft (68-81 Nm), use
Loctite® 243™ (Loctite is a registered trademark
of Henkel Corporation. 243 is a trademark of
Henkel Corporation).
Plug: 35-40 lbf/ft (47-54 Nm).
B.
C. Handle: 400 lbf/ft (542 Nm).

Troubleshooting

If the pneumatic machine does not start, has low
power or uneven performance, check the following
points.
Check that the insertion tool being used has the
♦
correct shank dimension.
Check that the pneumatic machine is getting the
♦
correct amount of lubricant. Too much lubrication
can cause starting problems, low power or
uneven performance.
Check that the compressed air system supplies
♦
the machine with sufficient air pressure to give
full power.
Check that the dimension and length of the air
♦
hose are according to the recommendations. See
"Installation".
If there is a risk of freezing, check that the
♦
machine's exhaust ports are not blocked.
If the machine function is still not satisfactory after
♦
this procedure, contact an authorised service
workshop.
16

Storage

>
>
>
A

Disposal

B
A used machine must be treated and disposed of in
such a way that the greatest possible portion of the
material can be recycled and any negative influence
on the environment is kept as low as possible, and
in respect to local restrictions.
C
Clean the machine properly before storage, in
order to avoid hazardous substances. See "Dust
and fume hazard"
Pour approximately 1 ⁄ oz (5 cl) of oil directly into
2
the air inlet nipple, connect the machine to the
compressed air supply and start it for a few
seconds.
Always store the machine in a dry place.
9800 0606 90a | Original instructions
CP 4123, CP 4125