Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Your bottle cooler has 4 leveling legs. After properly placing your bottle cooler in its final position, you
can level your bottle cooler.
Leveling legs can be adjusted by turning them clockwise to raise your bottle cooler or by turning them
counterclockwise to lower your bottle cooler.
Install the legs by screwing in the legs into the preset screw holes. (Please note that the leg which
stands on the hinge is the shorter leg.)
PROPER AIR CIRCULATION
To assure your bottle cooler works at the maximum efficiency it was designed for, you should install it in
a location where there is proper air circulation and electrical connections.
The following are recommended clearances around the bottle cooler
Sides............2 inches. (50mm)
Top.................2 inches. (50mm)
Back ...............2 inches. (50mm)
Do not over fill your bottle cooler for proper internal air circulation.
NOTE: Allow enough space in the front of the unit to open the door to 120°.
ELECTRICAL REQUIREMENT
Make sure there is a suitable power Outlet (220-240V~ 50/60Hz) with proper earthing to power the bottle
cooler.
Avoid the use of two-pin adapters or cutting off the third earthing pin in order to accommodate a two
plug outlet. This is a dangerous practice since it pro vides no effective grounding for the bottle cooler and
may result in shock haz ard.
USE OF EXTENSION CORDS
Avoid the use of an extension cord because of potential safety hazards under certain conditions. If it is
necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug
and a 3-slot outlet that will accept the plug. The marked rating of the extension cord must be equal to or
greater than the electrical rating of the appliance. (2 Ampere).
INSTALL LIMITATIONS
Do not install your bottle cooler in any location not properly insulated or heated e.g. garage etc.
Select a suitable location for the bottle cooler on a hard even surface away from direct sunlight or heat
source e.g. radiators, baseboard heaters, cooking appliances etc. Any surface unevenness should be
corrected with the leveling legs located on the front and rear bottom corners of the bottle cooler. Avoid
placing unit where there may be electrical interference.
Your bottle cooler is designed for free-standing installation only. It is not designed for built-in application.
NOTE: To minimize the risk of rusting, leakage and insulation damage, avoid placing the unit in a place
where heavy moisture is present. Under no circumstances spill or directly apply water onto or into the
unit.
INSTALLING THE VENTILATION SPACE
Important: to ensure good ventilation, please fit the spacer (provided) onto the proper location (as
shown below).
26
VS1210b.indd 26
8/25/2016 2:45:18 PM
Tabla de contenido
