Initial Operation; Proper Use; Remaining Hazards - Scheppach bg150 Traducción De La Instrucción De Original

Initial Operation

Before initial operation regard the following points:
• Turn machine on with the main switch. Wait until
grinding wheel has reached its operational speed before
starting to work.
• Press the work piece firmly to the work rest and move it
from one side to the other slowly and constantly on the
grinding wheel.
• Grinding may slow down the wheels. Reduce pressure on
the work piece until the wheel regain their speed.
Important note:
• Hold on to small work pieces with a pair of pliers or
similar tool.
• Never grind on the side of the wheels!
• As most materials gain heat while being grinded please
be careful with the work piece.
Changing the grinding wheels
Important note: In order to prevent injuries from acci-
dentally starting the machine the machine's main switch
must be turned off before changing a grinding wheel. Pull
power plug!
• Loosen the spark gard and the eye shield and pull out as
far as possible. Do not remove these parts!
• Loosen work rest and pull out as far as possible.
• Dissemble screws and pull off end plate.
• Take off outside flange and the old grinding wheel, then
assmeble the new one.
Important note:
• Do not remove the pieces of card board on the sides of
the wheel, as they are intended for strengthening the
grip of the Flange against the grinding wheels.
• Examine the new grinding wheels on cracks or other
visible damages and dispose if necessary.
• Mount flange and nut again.
• Do not tighten the screw by force. This can cause the
grinding wheel to break.
• Mount end plate.
• Mount work rest, spark guard and eye shield according
to installation instructions.
8 english

Proper Use

• The machine meets the currently valid EU machine
directive.
• The manufacturer's safety, operation and maintenance
instructions as well as the technical data given in the
calibrations and dimensions must be adhered to.
• Relevant accident prevention regulations and other
generally recognized safety and technical rules must
also be adhered to.
• The machine may only be used, maintained or
repaired by trained persons who are familiar with the
machine and have been informed about the dangers.
Unauthorized modifications of the machine exclude a
liability of the manufacturer for damages resulting from
the modifications.
• The machine is intended for use only with original spare
parts and original tools from the producer.
• Any other use is considered to be not intended. The
manufacturer excludes any liability for resulting
damages, the risk is exclusively borne by the user.

Remaining hazards

The machine has been built using modern technology and
in accordance with recognized safety rules.
Some hazards, however, may still remain.
• The grinding wheel poses a danger of injury to fingers
and hands by improper feeding or placement of tools.
• Danger of injury from thrown tools due to improper
holding or feeding.
• The use of incorrect or damaged mains cables can lead
to elctrical injuries.
• Although having regarded all considerable rules there
may still remain not obvious remaining hazrds.
• Minimize remaining hazards by following the instructions
in "Safety Rules", "Use only as authorized" and in the
entire operating manual.