Operation; Setting The Working Positions; Switching On And Off - Deltafox DG-ESA 1332 Traducción Del Manual De Instrucciones Original

Mounting the collection bag on the
implement:
3. Lift the impact protector (12).
4. Push the pins on the collection bag
rods into the socket in the implement
case.
5. Release the impact protector (12) so
that it holds the collection bag (11) in
its position.
Removing and emptying the collection
bag:
6. Lift the impact protector (12) and take
out the collection bag (11).

Operation

Please observe local regulations
concerning noise protection.

Setting the working positions

The implement has 5 principal position
settings:
+10 mm :
This position sets the maximum safety
spacing between the tool and the floor.
-3 mm : Working position
Set this position when working with a new
implement.
-3 to -12 mm :
The working position can be lowered with
increased knife and sprung tine wear.
Wear can be identified from an increas-
ingly poor result.
The readjusting depth amounts to approx.
3 mm per setting.
Transport position
Readjustment
positions
When the implement is delivered
it is in the Transport Position
(+10 mm) setting.
1. The implement must be switched off
to set the working position.
2. Adjust the depth adjustment lever
( A 10) and allow it to lock into place
in the desired position.
Selection of a readjustment posi-
tion without the corresponding
wear can overload the motor and
damage the cylinder.
D

Switching on and off

Before switching on the imple-
ment ensure that it is not in con-
tact with any objects. Keep your
feet and hands well away from the
cylinder and the ejector opening.
Danger of injury!
1. Place the implement on a level lawn
surface.
2. Connect the extension cord to the
power cable (18).
3. Form a loop in the end of the power ca-
ble and hang it into the strain relief (15).
4. Connect the implement to the mains
voltage.
5. To switch on, press the electronic
switch lock (1) on the handlebar and
then pull the start handle (2) towards
the handlebar. Release the electronic
switch lock (1).
6. To switch off release the starting lever
(2).
Overload protection: The motor
is automatically switched off when
the implement is overloaded. Re-
lease the starting lever and reset
GB
33