Krups COMBINE INOX Manual De Instrucciones página 79

English
- RINSING OUT THE STEAM CIRCUIT.
Before using the steam function for the first time, the steam circuit should be cleaned.
n Fill the water tank
n Turn the appliance on by pressing the
n Place a recipient underneath the steam nozzle.
n Turn the switch to the
n When the
button has stopped flashing, turn the switch to the
until steam is formed.
n Keep the steam production going for at least 30 seconds.
2. MAKING AN ESPRESSO
In order to release all the aromas of the coffee and ensure your complete satisfaction, this machine
pre-infuses each coffee. The pump works 3 seconds, stops the following 3 seconds and then the cycle
continues until the end of the preparation.
PREHEATING THE ACCESSORIES
n For the best results, we recommend that you preheat the accessories (filter holder and cups)
without ground coffee. To do so:
n Fill the water tank and turn the machine on (fig. 1, 2, 3 and 4).
n Put the filter holder in place, place the cups below.
n As soon as the appliance reaches the required temperature, the light stops flashing.
n Turn the switch to the "coffee" position (fig.8).
n When the cups are filled with hot water, turn the switch to the "off" position (fig.9).
n Remove the cups.
n Unlock the filter holder: press "OPEN" while turning the filter holder to the left and remove it from the
machine (fig. 10).
Note: When the appliance is hot, the espresso cups can be preheated on the cup warming plate.
WITH ESPRESSO GROUND COFFEE
The type of coffee you choose will determine the strength and taste of your espresso.
n Fill the water tank and turn the machine on (fig. 1, 2, 3 and 4). During the pre-heating phase, the
indicator lamp will flash.
n Using the measuring spoon, place the espresso ground coffee in the filter holder: one spoon (full to
the brim) per cup (fig.5).
n Remove the excess espresso ground coffee from the edge of the filter.
IMPORTANT:
Do not tamp the coffee down in the filter holder. The coffee is automatically tamped
using the KTS "Krups Tamping System".
n Only use Espresso Ground Coffee. Do not use any other coffee such as instant coffee.
n Insert the filter holder in the appliance by turning it to the right as far as it will go, up to the stop
(fig.7).
n Put one or two cups under the filter holder.
n As soon as the appliance reaches the required temperature, the light stops flashing.
n Turn the switch to the "coffee" position (fig.8).
n When you have the desired amount of coffee, turn the switch to the "off" position (fig.9)
n Unlock the filter holder: press "OPEN" while turning the filter holder to the left and remove it from the
machine (fig. 10).
76
button.
position, the button starts to flash.
position and let the water run