You are not satisfied with the way the appliance functions?
If the appliance does not function the way you expect it to, consult the following table and read the relevant sections in the directions for use!
Problem:
The switch does not function
The appliance has suddenly stop-
ped running
The chopping, slicing or grating
result is not optimal
The result when whisking eggs is
not optimal
The result when whipping cream
is not optimal
The beater slips or bends
The dough is swung around in
the bowl
Possible solution:
Turn bowl and/or lid in the direction indicated as far as possible (until you hear a 'click').
Make sure that the arrows on the bowl and on the appliance as well as on the bowl and on the lid are
placed directly opposite each other (see fig. 2 and 6).
Make sure that the blender jar or the screw cap have been properly placed and turn them in the direction
indicated as far as possible.
This is probably the automatic cut-out system that has cut off the power supply to the appliance because
it has overheated.
- Unplug the appliance
- Set the switch to position O
- Let the appliance cool down for 15 minutes
- Put the mains plug back in the socket
- Switch on the appliance again.
If the automatic cut-out system is activated repeatedly, contact your Philips dealer or the Philips Service
Centre in your country.
Select the correct speed. Look at the indications on the appliance and in the directions for use.
You can try adding some lemon juice or salt. Make sure the beater and the bowl are grease-free and
select the right speed.
Use the beater. Use cooled whipping cream (approximately 6 °C).
Only use the beater to whip cream, eggs/egg whites and liquids. Do not use it to prepare batter, cake
mixture or dough!
Follow the instructions given in the directions for use carefully. Never add too much water.
Always use the accessory indicated in the table.
Do not exceed the maximum kneading time indicated.
17