Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

InstallatIon
InstructIons
Before You Begin
IMPortant
Save these instructions for local
inspector's use.
IMPortant
Observe all governing codes and
coordinates.
note to installer
instructions with the Consumer.
note to Consumer
future reference.
skill level
– Installation of this appliance requires
basic mechanical and electrical skills.
 MountInG sPacE
This Over the Range Microwave Oven requires a mounting space
on a wall as shown in Figure 1. It is designed to be used with
standard 12" wall cabinets.
12"
15.5"
At least 2"
Backsplash
Read these instructions completely and carefully.
– Be sure to leave these
– Keep these instructions for
30"
30" or more
from cooking
surface
66" or more
from floor
Figure 1
over the range
Microwave oven
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not covered
under the Warranty.
Please read all instructions thoroughly before installing
the Over the Range Microwave Oven. Two people are
recommended to install this product.
If a new electrical outlet is required, its installation should
be completed by a qualified electrician before the Over the
Range Microwave Oven is installed. See 3 ELECTRICAL
GROUNDING INSTRUCTIONS on page 2.
2 Wall constructIon
This Over the Range Microwave Oven should be mounted against
and supported by a flat vertical wall. The wall must be flat for proper
installation. If the wall is not flat, use spacers to fill in the gaps. Wall
construction should be a minimum of 2" x 4" wood studding and
3/8" or more thick dry wall or plaster/lath. The mounting surfaces
must be capable of supporting weight of 110 pounds—the oven
and contents—AND the weight of all items which would normally
be stored in the top cabinet above the unit.
the unit should be attached to a minimum of one 2" x 4" wall
stud.
To find the location of the studs, one of the following methods may
be used:
A. Use a stud finder, a magnetic device which locates the nails in
the stud.
B. Use a hammer to tap lightly across the mounting surface to
find a solid sound. This will indicate stud location.
The center of the stud can be located by probing the wall with a
small nail to find the edges of the stud and then placing a mark
halfway between the edges. The center of any adjacent studs will
normally be 16" or 24" to either side of this mark.
nEEd HElP?
For customers in the United States, call: 1-800-944-9044
For customers in Canada, call: 1-800-213-9397 (English)
1-800-668-4606 ext.8199 (French)
rEad carEfully. KEEP tHEsE InstructIons.

P/N 316495006
TINSEB484MRR0
E
Tabla de contenido
loading

Resumen de contenidos para Electrolux EI30MH55GS

  • Página 9 InstruccIonEs Horno microondas dE InstalacIÓn sobre la estufa antes De ComenZar Lea estas instrucciones completa y detalladamente. IMPortantE • La correcta instalación es responsabilidad del instalador. • Guarde estas instrucciones para uso del inspector local. • La garantía no cubre la falla del producto por instalación inapropiada.
  • Página 10: Instrucciones De Conexión Eléctrica A Tierra

    2. Ni Electrolux ni el distribuidor aceptan ninguna responsabilidad por los daños al horno o las lesiones personales causados por no seguir CODO DE 90˚ (10 PIES) CODO DE 45˚...
  • Página 11: Preparación Del Horno

    Instrucciones de instalación 6 tornIllErÍa dE InstalacIÓn 7 PrEParacIÓn dEl Horno Los elementos de la tornillería de instalación del 1 - 7 están en una 1. Voltee el horno de costado. Vea la Figura 5. bolsa pequeña. Los elementos 8 - " vienen por separado. Todos los 2.
  • Página 12: Sistema De Ventilación

    Instrucciones de instalación 8 sIstEMa dE VEntIlacIÓn (PrEParacIÓn dEl Horno Para su InstalacIÓn) Este Horno microondas sobre la estufa está diseñado para adaptarse a tres tipos de sistemas de ventilación de campana extractora. Seleccione el tipo correspondiente a su instalación. recirculante —...
  • Página 13 Instrucciones de instalación (c) EscaPE VErtIcal: EXtraccIÓn HacIa El EXtErIor 1. Retire y guarde 2 tornillos del borde posterior y 3 tornillos de la parte superior central de la cubierta del ventilador. Retire el soporte de la cubierta del ventilador deslizándolo en la dirección contraria de la flecha que aparece en el soporte, como se muestra en la Figura 11.
  • Página 14: Instalación Del Horno

    Instrucciones de instalación 9 InstalacIÓn dEl Horno Placa dE MontaJE 1. Separe 4 pernos acodados de la TORNILLERÍA DE INSTALACIÓN, ESTE HORNO NO PUEDE INSTALARSE APROPIADAMENTE SI de las tuercas articuladas. NO SE CONSULTAN LAS INSTRUCCIONES DE MONTAJE QUE SE 2.
  • Página 15: Dimensiones Exteriores

    Vea la Figura 20. 2. Utilice dos tornillos autorroscantes para asegurar las palanquillas que están en la base del horno. Vea la Figura 21. Figura 22 dIMEnsIonEs EXtErIorEs Modelos EI30MH55GS/GB/GW: " " (ancho) x 17 (alto) x 16 "(profundidad)

Este manual también es adecuado para:

Ei30mh55gz

Tabla de contenido